數顯角度測量儀 M-30L

安裝要點:

傳感器的信號線要遠離動力線和接觸器等強干抗設備。電源供電范圍:交流或直流9~~24V,過高的電壓可能會損壞本設備。傳感器的安裝面必須緊固在上下擺動的角位移面,并且要和擺動方向相同(見傳感器上的標識)。
調試要點(必要的2步)
A、請檢查設備的運行方向和測量顯示方向是否一致,如果不一致,請將傳感器的方向掉轉
B、將設備調整到0度的位置,然后在此位置設置,將當前測量值清零

Install Essentials
Sensor signal cables away from power lines and interference equipment such as contactors. Scope of supply: AC or DC 9--24V, high voltage may damage the device Bobbingsensor mounting surface must be fastened at corners Moving surfaces, and swing in the same direction(see marks on the sensor).
Debugging points(need 2 step)
A, Check the running direction and measure the display orientation is consistent, if not, move the sensor direction turned
B, Adjust the device to O degree position, then this location is set, the current measured values to zero